Bolt and Rust Release Spray with Freezing Effect Debbex (400ml)

This freeze-effect spray-on bolt and rust remover is ideal for loosening corroded bolted joints, sliding bearings or tie rods.

It utilises a shock-freezing effect to loosen seized, rusted and corroded parts. The bolt loosener rapidly cools the parts to as low as -40°C, causing microscopic cracks. This allows the oil to penetrate directly into the rust layer via capillary action.

The loosened parts are then easier to separate, whilst remaining lubricated and protected against further corrosion.

Standard hazard statements
H222 Extremely flammable aerosol.
H229 Pressurised container: may burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.

Precautionary statements
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray onto open flames or other sources of ignition.
P251 Do not pierce or burn, even after use.
P261 Avoid inhaling dust/fumes/gas/mist/vapours/aerosols.
P271 Use only outdoors or in well-ventilated areas.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P312 If you feel unwell, call a POISON INFORMATION CENTRE/doctor
. P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container at a recycling centre in the hazardous waste section. 

Additional information
Not applicable.

Hazardous substances: Propan-2-ol.

Signal word: Danger.

UFI identifier: 8M60-SONX-Y005-R7GQ.

Always follow the information on the product label.

Contact details for the manufacturer/distributor in the Czech Republic: